How the VCM works in a 2008 Honda Accord V6 Engine

VCM = Variable Cylinder Management.

Here's how it works;

i-VTEC with 3-stage Advanced Variable Cylinder Management™ (VCM™)
The Accord’s available SOHC V-6 with automatic transmission includes i-VTEC with Advanced VCM. With the boost in fuel efficiency attributable to VCM, the larger and more powerful Accord V-6 with automatic transmission actually gets better fuel economy than its smaller, less powerful predecessor when tested with the same methodology.

VCM Operation
To help improve the fuel efficiency of the V-6 engine available with the 5-speed automatic transmission, the latest generation of Honda’s VCM is used. This is the first application of VCM on a non-hybrid Accord model. Unlike previous VCM systems that switched between three- and six-cylinder operation, the Accord’s system can operate on three, four or all six cylinders.

During start-up, acceleration or when climbing hills – any time high power output is required – the engine operates on all six cylinders. During moderate speed cruising and at low engine loads, the system operates just one bank of three cylinders. For moderate acceleration, higher-speed cruising and mild hills, the engine operates on four cylinders.

With three operating modes, the VCM system can finely tailor the working displacement of the engine to match the driving requirements from moment to moment. Since the system automatically closes both the intake and exhaust valves of the cylinders that are not used, pumping losses associated with intake and exhaust are eliminated and fuel economy gets a further boost. The VCM system combines maximum performance and maximum fuel economy – two characteristics that don’t typically coexist in conventional engines.

VCM deactivates specific cylinders by using the VTEC (Variable Valve-Timing and Lift Electronic Control) system to close the intake and exhaust valves while the Powertrain Control Module simultaneously cuts fuel to those cylinders. When operating on three cylinders, the rear cylinder bank is shut down. When running on four cylinders, the left and center cylinders of the front bank operate, and the right and center cylinders of the rear bank operate.

The spark plugs continue to fire in inactive cylinders to minimize plug temperature loss and prevent fouling induced from incomplete combustion during cylinder re-activation.

The system is electronically controlled, and uses special integrated spool valves that do double duty as rocker-shaft holders in the cylinder heads. Based on commands from the system’s electronic control unit, the spool valves selectively direct oil pressure to the rocker arms for specific cylinders. This oil pressure in turn drives synchronizing pistons that connect and disconnect the rocker arms.

The VCM system monitors throttle position, vehicle speed, engine speed, automatic-transmission gear selection and other factors to determine the correct cylinder activation scheme for the operating conditions. In addition, the system determines whether engine oil pressure is suitable for VCM switching and whether catalytic-converter temperature will remain in the proper range. To smooth the transition between activating or deactivating cylinders, the system adjusts ignition timing, drive-by-wire throttle position and turns the torque converter lock-up on and off. As a result, the transition between three-, four-, and six-cylinder operation is unnoticeable to the driver.